Hammer Mill is the core device of artificial sand, in addition to the commonly used sand making machine, the roller Hammer Mill can also be used to sand, and it is called the roller sand making machine, which is suitable for various medium Ore and rocks below hardness are widely used in industrial sectors such as mineralization, chemistry, cement, and buildings. It uses special roller designs that make him more flexible crushing methods in crushing, improve the quality and efficiency of material crushing. It does not require quadratic crushing during operation, so that the pulverization rate is extremely low, the finished material particles produced are uniform, the grain level is reasonable, the grade is very wide
The roller Hammer MILL is equipped with a wedge or spacer adjustment device, the top end of the wedge device With adjustment bolts, when the adjustment bolts pull the wedge up, the wedge will be separated from the movable roller, that is, the two roller gap becomes large, the particle size is large, when the wedge is down, the active roller The two-wheel gap becomes smaller under the action of the compression spring, and the particle size of the discharge is small. The gasket device adjusts the particle size size by increasing the amount or thickness of the gasket. When the gasket is increased, the two roller gap becomes large, when the gasket is reduced, the two roller gap becomes small, and the particle size is small. .
Precautions for roller Hammer Mill in daily use
1, device Periodically lubricate: Strengthen the inspection of roller Hammer Mill, and fuel to the lubrication portion of the device to keep the equipment in a good lubrication.
2, stopping the clogging failure: The viscous material is easy to block the crushing space, and if you are handling the clogging failure, stop processing, and do not smash the ore during the operation.
3, to reinforce the ore repellent: fall into the unbroken material (brazing head, etc.) of the roll, can damage Hammer Mill and cause parking accidents, so it should be in Hammer MInstall the iron apparatus before ILL.
4, periodically for roller Hammer Mill: After long run, the product size will be over because the wear of the roller surface is large. Small. At this point, you should pay attention to adjust the discharge port or check and repair the roller equipment.
5, pay attention to safety when crushing material: Please note that there is a bulk ore in the treated material, which is easily squeezed from the crushing space, so avoid Injury damage to personal or equipment.
ALPA Heavy Industry A large manufacturer of various types of mine equipment, has more than 30 years of history and experience, can Users provide high quality equipment, more intimate services; there are currently 5-450 tons of roller Hammer Mill, users can visit the factory, and AlPA has always been self-produced, users can buy at the factory price. To a suitable device.